Maclaren Twin triumph Operations Instructions Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
3
EN
Instructions
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.
YOUR CHILDREN’S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS.
1 TO OPEN THE STROLLER
A Release BOTH storage clips.
B Open out the stroller.
C Using foot, push BOTH footplates down fully to engage the primary
locks.
WARNING: Ensure that all locking devices are fully engaged before use.
2 TO OPERATE BRAKES
A TO ENGAGE BRAKES: With foot, push down the ON lever.
B TO RELEASE BRAKES: Push down on BOTH brake levers.
Parking device shall be engaged during the loading and unloading of children.
3 TO OPERATE FRONT WHEEL SWIVEL LOCKS
A TO LOCK SWIVELS: Align front wheels and press down on locking levers.
B TO UNLOCK SWIVELS: Raise locking levers.
4 SEAT BELT/SHOULDER HARNESS OPERATION
WARNING: Avoid serious injury from falling or sliding out. Always use the crotch
strap in combination with the waist belt and shoulder straps.
TO FIT HARNESS:
A Insert both fasteners securely into clasp.
B Adjust strap lengths by sliding buckles. Belt and harness should be snug.
C ‘D’ rings are included for an additional harness, if desired.
TO RELEASE HARNESS:
D Squeeze fastener prongs and pull apart.
5 TO ADJUST SEAT RECLINE
A TO RECLINE SEAT BACK: Locate adjustment strap on rear of seat back.
Squeeze fastener prongs and pull apart.
B TO RAISE SEAT BACK: From rear of stroller push seat back to upright
position and insert fastener securely into clasp.
C Further intermediate adjustment can be made by shortening or
lengthening the strap.
D After adjustment, secure the loose strap by attaching the Velcro pads.
6 ATTACHING THE HOOD
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum carrying capacity of hood pouch - 1.1 lb (0.5kg.) per pouch.
A With stroller open, clip the hood to the handle tubes just above the
retaining rivets.
B Place the rear apron behind seat backs and attach poppers.
C Extend hoods and press down on both side hinges of each hood to lock
open.
D The hood is removed by firmly pressing down on the hood release tabs.
7 TO FIT THE RAIN APRON
A Place the apron over the hood.
B Attach two eyelets (one each side) to the hood clips.
C Attach two eyelets (one each side) to the front legs.
8 TO FIT THE SHOPPING BAGS
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum load 4.4lb (2kg) evenly distributed.
The stroller may be folded with the bags still attached but all contents
must be removed.
Failure to do this could damage stroller and contents of shopping bag.
A Place bags on the ‘X’ frame under seat with lowest edge of bag at front.
B Attach front straps to front legs just below seats.
C Attach rear straps to rear legs just above horizontal tie bars.
9 REMOVING AND REFITTING THE SEAT LINERS
The seat liners may be removed for washing.
The seat liners are reversible.
A Unclip all shoulder and waist straps.
B Twist crotch strap buckle and feed up through seat base and liner holes.
C Detach Velcro retaining straps from seat rear and slide seat liner from
seat base.
D feed waist straps and shoulder harness straps through holes in liner.
E Reverse this procedure to refit the seat liners ensuring crotch strap
buckle passes through seat liner hole and seat base hole.
10 REMOVING AND REFITTING THE SEAT COVER
Remove rain apron, hood and seat liners from stroller if fitted.
A Twist shoulder strap end buckles and feed through holes.
B The waist harness back strap is fixed to the chassis behind the seat.
To remove, twist the buckles on each end of the harness back strap
and unthread from the ‘D rings attached to the chassis. IMORTANT – It
is important that the strap be rethreaded through the ‘D’ rings after the
seat has been refitted. Failure to do so will endanger your child.
C Unclip seat cover retaining straps.
D Unfasten seat fabric from handle tubes and seat base.
E Slide fabric from seat back and base.
F Reverse this procedure to refit the seat cover and harnesses ensuring
seat back support tubes are inserted into fabric fold.
11 TO FOLD THE STROLLER
Ensure the seat back is in its fullest upright position and the hood(if fitted) is
folded back.
Remove contents of shopping bag.
It is recommended that the harness is fastened before folding the stroller.
A Ensure the seat backs are in the fullest upright position.
B Fold back the hood (if fitted).
C Using foot, lift up BOTH footplates to release primary locks.
D Push down on secondary lock lever.
E Grip handles and push forward.
F Compress folded stroller and engage BOTH storage clips.
Page view 9
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments